Chapter 4. Service Checkout And Symptom-To-Fru Index; Service Checkout; Problem Determination Tips - Lenovo ThinkSmart Hardware Maintenance Manual

Hide thumbs Also See for ThinkSmart:
Table of Contents

Advertisement

Chapter 4. Service checkout and symptom-to-FRU index

This chapter provides information about general service checkout and symptom-to-FRU index.

Service checkout

Attention: The drives in the hub you are servicing might have been rearranged or the drive startup sequence
changed. Be extremely careful during write operations such as copying, saving, or formatting. Data or
programs can be overwritten if you select an incorrect drive.
General error messages appear if a problem or conflict is found by a program, the operating system, or both.
For an explanation of these messages, refer to the information supplied with that software package.
Use the following procedure to help determine the cause of the problem:
1. Turn off the hub and all external devices.
2. Check all cables and power cords.
3. Set all display controls to the middle position.
4. Turn on all external devices.
5. Turn on the hub.
• Look for displayed error codes.
• Look for readable instructions or a main menu on the display.
If you did not receive the correct response, proceed to step 6 on page 31.
If you do receive the correct response, proceed to step 7 on page 31.
6. Look at the following conditions and follow the instructions:
• If the hub displays a POST error, go to "POST error codes" on page 33.
• If the hub hangs and no error is displayed, continue at step 7 on page 31.
7. Run the Diagnostic programs. See "Diagnostics" on page 43.
• If you receive an error, replace the part that the diagnostic program calls out.
• If the test stops and you cannot continue, replace the last device tested.

Problem determination tips

Due to the variety of hardware and software combinations that can be encountered, use the following
information to assist you in problem determination. If possible, have this information available when
requesting assistance from Service Support and Engineering functions.
• Machine type and model
• Processor or hard disk drive upgrades
• Failure symptom
– Do diagnostics indicate a failure?
– What, when, where, single, or multiple systems?
– Is the failure repeatable?
– Has this configuration ever worked?
– If it has been working, what changes were made prior to its failing?
– Is this the original reported failure?
© Copyright Lenovo 2020
31

Advertisement

Table of Contents
loading

Table of Contents