TIE DOWN 72874 Manual

www.tiedown.com
Failure to read, understand and follow these
instructions may cause bodily injury or death.
The Tie Down Step-N-Safe Extension Ladder Walk-thru is designed
to fit most ladder profiles in the market. Fitting from Type II to
Special Duty Type IAA, the Step-N-Safe incorporates a dual
clamping, non-penetrating, system that locks the rail extensions on
the ladder rails. The addition of the Step-N-Safe to virtually any
extension ladder will allow for a much safer transition to an
elevated walking surface. The Step-N-Safe meets compliance
standards OSHA 1910 and 1926.
WARNING
KEEP EXTENSION LADDERS A MINIMUM 10 FT.
CLEAR OF ALL ELECTRICAL WIRES AND EQUIPMENT.
BE AWARE OF OVERHEAD WIRES BEFORE RAISING
TRACK SECTIONS. ELECTRICITY KILLS!
Per OSHA regulations, always maintain three points of
contact while assembling and climbing on a ladder.
Online
Instructions
Remember to
always erect
your ladder
using the
4:1 rule
WARNING: This product can expose you to chemicals including Nickel, which is known to the
State of California to cause cancer. For more information go to: www.P65Warnings.ca.gov
4
1
404-344-0000 • www.tiedown.com
605 Stonehill Drive SW, Atlanta, GA 30336
Step-N-Safe Extension
Ladder Walk-Thru
Part ID: 72874
Step-N-Safe Extension
Ladder Walk-Thru
Professional
Part ID: 72875
Step-N-Safe Extension
Ladder Walk-Thru
Safety Gate
Part ID: 72877
See back page
Instructions #08404 (E1893 - Rev. 1/4/22)
sales@tiedown.com
See Page 2
Declaration
of Conformity
See Page 3
Declaration
of Conformity