Installation - HIKVISION HWT-T250-M User Manual

Figure 1-6 Overview of Type VI Camera
Note:
Press and hold the switch button for 5 seconds to switch
the video output. Four kinds of video outputs are
available: TVI, AHD, CVI, and CVBS.

2 Installation

Before you start:
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with your

power output to avoid the damage.
Make sure the wall is strong enough to withstand three

times the weight of the camera and the mount.
If the wall is cement, insert expansion bolts before

installing the camera. If the wall is wooden, use self-
tapping screws to secure the camera.
If the product does not function properly, contact your

dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I and Type II Camera
Before you start:
Type I and type II cameras share the same installation,
and we take type I camera as the example to describe the
installation method.
Both wall mounting and ceiling mounting are suitable for
the camera. We take ceiling mounting as an example in
this section. You can take the steps of ceiling mounting as
a reference, when adopting wall mounting.
Steps:
1. Disassemble the turret camera by rotating the camera
to align the notch to one of the marks, as shown in the
figure below.
Figure 2-1 Disassemble the Camera
2. Remove the mounting base from the camera body
with a flat object, e.g., a coin.
3. Paste the drill template (supplied) to the place where
you want to install the camera.
4. Drill the screw holes, and the cable hole (optional) on
the ceiling according to the drill template.
批注 [KL7]: 海螺 17&14, 海螺 13