Table of Contents
Advertisement
Figure 2-8 Attach the Mounting Base to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement ceiling, expansion bolts are required
to fix the camera. For wooden ceiling, self-tapping
screws are required.
5. Route the cables through the cable hole, or the side
opening.
6. Combine the camera body with the mounting base.
1). Put the camera body in the mounting base.
2). Align the notch to the clip plate, and rotate the
enclosure a little bit.
3). Tighten the screw to secure the camera on the
mounting base.
Figure 2-9 Secure the Camera with Mounting Base
7. Connect the corresponding cables, such as power
cord, and video cable.
8. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
Pan Position
[0° to 360°]
Tilt Position
[0° to 75°]
Figure 2-10 3-axis Adjustment
1). Rotate the enclosure to adjust the pan position [0°
to 360°].
2). Move the camera body up and down to adjust the
tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
2.3 Installation of Type IV Camera
Rotation Position
[0° to 360°]
批注 [KL9]: 这句话要修改
批注 [KL10]: 海螺 13 全金属
Advertisement
Table of Contents
