Installation; Mounting - Grundfos SI 010 CNV Installation And Operating Instructions Manual

4. Installation

SI 010 CNV is designed for DIN rail mounting inside a control cabinet.
An IP66 box for the mounting of SI 010 CNV is available as an accessory.

4.1 Mounting

When SI 010 CNV is mounted in a control cabinet also containing a
frequency converter, it is especially important to ensure an EMC-correct
installation of both SI 010 CNV and the frequency converter.
Consequently, the following rules must be observed:
• All cable screens must be connected to earth.
• All units in the control cabinet must be connected to earth.
Mounting on DIN rail
Use a 35 mm DIN rail (EN 50022).
1. Pull out the clip using a screwdriver (see fig. 9).
2. Mount SI 010 CNV on the DIN rail.
3. Make sure that the spring pushes back the clip so that SI 010 CNV is kept
in place.
Fig. 9 Mounting SI 010 CNV on DIN rail
Dismounting from DIN rail
1. Pull out the clip using a screwdriver (see fig. 9).
2. Tip SI 010 CNV free of the DIN rail.
13