Other Hot Beverage; Water Level Control Of Boiler; How To Access The Programming Function - La Cimbali M21 Junior DT/1 Use And Installation

Scalding hazard!
insulating devices
steam wands.
Steam dispensing
Plunge the steam jet pipe (6) into the liquid to be heated in a
suitable container and turn the steam adjustment knob (7).
When the liquid is hot, stop the flow of steam by turning
knob (7) the other way (towards "0").
Cleaning of steam dispensing pipes
At the conclusion of each steam dispensing
phase:
- Using a clean sponge, wash with hot water
removing any organic residue present. Rinse
carefully.
- clean the inside of the steam nozzle as
follows:
Turn the nozzle towards the cup tray and
carefully activate steam dispensing at least
once.
Heating milk for frothy coffee (cappuccino)
Use a tall narrow jug and fill it up to about the half-way mark.
Then plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for
a few seconds.
The machine is fitted with a series of automatic level control
devices to keep the water in the boiler at a pre-set level.
The indicator light (11) comes on when water enters the
boiler.
To enter the programming phase, keep button (20) pressed
for about 10 seconds. The programming phase is indicated
by the flashing led (22).

13. Other hot beverage

13. Other hot beverage
Use the appropriate
to move the water and

14. Water level control of boiler

15. How to access the programming function

7
6
When the required amount of froth has been made and the
temperature is sufficiently high, stop the flow of steam by
turning knob (7) the other way (towards "0").
When the steam jet pipe (6) is no longer required, clean it
thoroughly with a sponge and a clean cloth.
Dispensing hot water
Position a container under the hot water pipe (8) and turn
the hot water dispensing knob (9).
When the required amount has been dispensed, stop the
flow of hot waterby turning knob (9) the other way (towards
"0").
22
11
Once the dosing of the various coffee buttons is completed,
press button (20) for about 1 second to terminate this
phase.
10 EN
9
8