Table of Contents
Advertisement
Imager Orientation
When the IT4X00 Series is mounted with the label pointing up, captured images appear right side up.
Connector Position and Flex Orientation
Connector
The interface connector is a Molex 0.30mm (.012") Easy-On™ Type Right Angle, SMT, ZIF, Bottom Contact Style Receptacle
part number 54393-2192. See
Connector Pinout
Pin
Signal
1
Ground
2
LED Current Control PWM
3
Ground
4
Horizontal Sync (H Data Valid)
5
Vertical Sync (V Data Valid)
6
Aimer On
7
Illumination On
8
Power Enable
9
2
I
C Data (SDA)
10
2
I
C Clock (SCL)
IMAGETEAM™ 4X00 Series Integration Manual
Flex
Interface Connector
on page 1-2 for details.
Description
Power and signal ground.
Input - Controls the LED current. A pulse width modulated signal based on a frequency of 7.5K Hz
reduces the current of the LED power supply. The relationship of current to duty cycle is inversely pro-
portional (the longer the duty cycle, the lower the current). Leave this pin unconnected if not using this
feature.
Power and signal ground.
Output - Definition varies according to the setting of the image registers. For the configuration defined in
this document, this signal is used as a data valid window. Polarity of this signal is selectable in register
address 0x01, Bit 1. Hand Held Products setting is 1 = active high window.
Output - Definition varies according to the setting of the image registers. For the configuration defined in
this document, this signal is used as a data valid window. Polarity of this signal is selectable in register
address 0x01, Bit 2. Hand Held Products setting is 0 = active low window.
Input - Active high on this line enables the LED power supply and turns on the 2 aiming LEDs. This line
may be pulse width modulated many times per horizontal line (based on pixel clock) in order to reduce
power.
Input - Active high on this line enables the LED power supply and turns on the 4 illumination LEDs. This
line may be pulse width modulated many times per horizontal line (based on pixel clock) in order to
reduce power.
Input - Active high enables the imager. A low on this line places the imager in a power down state.
Imager follows slave protocols with respect to this signal.
Imager follows slave protocols with respect to this signal.
Top
1 - 3
Advertisement
Table of Contents
