Command Execution Cancel; Visca Device Setting Commands; For Visca Network Administration - Tamron MP3010M-EV Technical Reference Manual

To cancel a command which has already been sent, send the Cancel command
(CommandCancel Command) as the next command. To cancel one of any two
commands which have been sent, use the cancel message.
Cancel Packet
Cancel 8X 2Y FF
X = 1 to 7: camera address, Y = socket number
An error message (Command Cancelled) will be returned for this command, but it is
not a fault. It indicates that the command has been canceled.
VISCA is a protocol, which normally supports a daisy chain of up to seven connected
cameras via RS-232C interface.
Before starting control of the camera module, be sure to send AddressSet Command
and IF_Clear Command as broadcast.
 AddressSet Command
Sets an address of a peripheral device. Use this when initializing the network, or
receiving the following network change message.
 Network Change
Sent from a peripheral device to a controller when the device is removed from or
added to the network. The address must be re-set when this message is received.
Tamron Co., Ltd.

Command Execution Cancel

Note
Y = socket number

4.4 VISCA Device Setting Commands

For VISCA Network Administration

52 / 79