Table of Contents
Advertisement
This uses CAM_RegisterValue Command.
The register setting command can set and change the camera default setting.
Register Setting Command (CAM_RegisterValue Command):
8x 01 04 24 mm 0p 0q FF
mm: Register No. (=00h to 7Fh)
pq: Register Value (=00h to FFh)
Register Inquiry Command (CAM_RegisterValueInq Command):
8x 09 04 24 mm FF
mm: Register No.
y0 50 0p 0p FF
pp: Register Value (returned from the camera)
Example: To set communication speed to 38400 bps
8x 01 04 24 00 00 02 FF
After sending this command, turn power off and back on (power reset) to resume
communication control at 38400 bps.
Note:
For the timing to reflect the changes made to the register settings, refer to the
Setting value reflection timing in "Register Settings" on the next page.
Tamron Co., Ltd.
3.30 Register setting
32 / 79
Advertisement
Table of Contents
