Hirose DF53 Series Assembly Procedure

1. Scope

This document specifies the cable assembly procedures of crimping the crimp contact to
the cable and inserting the contact to the crimp case for DF53 Series.
This document contains general guideline and operating suggestions to use this product
safely. If this product is used another way from being written in this document, unexpected
trouble such as connector breakage could happen. Please read through this document and
understand proper operation before using.

2. Part Number

Part No.
DF53-32PCF
DF53-*P-0.6C
* : Number of position.

3. Cable Assembly Procedure

3.1. Cable Stripping

Follow the Crimping Quality Standard (ETAD-H0921), and strip the cable jacket.
Make sure that there is no damage on the center conductor of the cable.

3.2. Crimping Process

Crimp the contact by using the applicator (AP105-DF53-32P).
Confirm that the crimp height and configuration meet the crimp condition and Crimping
Quality Standard (ETAD-H0921).

3.3. Crimped Contact Insertion to Crimp Case

Hold the cable of crimped contact and insert to each contact cavity of the crimp case.
(Insertion direction is as shown below.)
Before insertion
Crimped contact
COUNT DESCRIPTION OF REVISIONS
△
1
2
TITLE
DF53 Series cable assembly procedure
TECHICAL SPECIFICATION
FORM HC0011-9-1
Description
Crimp contact
Crimp case
Crimp socket
DIS-H-00009693
Remarks
Compatible cables : AWG 32 (ϕ0.4mm MAX)
After insertion
Insertion direction
DESIGNED
TH.SATO
APPROVED
CHECKED
DESIGNED
WRITTEN
ETAD-H0995-00
CHECKED
TT.OHSAKO 20210610
HIROSE ELECTRIC CO.,LTD.
HS.OKAWA 20200407
ST.WADA 20200407
TH.SATO 20200407
TH.SATO 20200407
△
1
DATE
1 / 5