Troubleshooting - Opera IMPULSE AUTO Instructions Manual

12. Troubleshooting

Power unit is not working.
Power unit is working, but
mattress replacement is
not inflating
and/or
Bottoming out is occurring
and/or
Patient leaves a deep
indentation at the contact
area which does not return
back to its original shape.
13 | Opera Beds | Opera Impulse Hybrid Mattress System Instructions and Technical Specifications | Version 2
Fault
Check if the power switch
Check if the power surge
has shut down the power
power unit's quick release
Verify that patient weight
Check if air cells are cut or
Inspection Procedure
Check if power cord is
firmly plugged into both
the control unit and the
electrical outlet.
is in the on position.
unit.
Make sure there is no
power failure.
Power unit does not
respond to possible
solutions.
Check CPR Pull Cord.
Check if mattress'
air hose couplers are
properly connected to
couplers.
setting is correct.
Inspect air filter for dust
and dirt.
Lift mattress coverlet up
to check if air cells are
connected correctly.
Lift mattress coverlet up
to check if air tubes are
kinked or obstructed.
cracked
Remedy
Secure power cord into
control unit and/or electrical
outlet.
Turn power switch to on
position.
A power surge may overload
the circuitry temporarily. Turn
the unit off, and check the
fuse for damage. Turn the
unit on again with normal
procedure.
Turn on and operate the unit
after power is restored to the
facility or home.
Please contact Opera on
0333 222 8584 for assistance.
Unzip mattress cover and
inspect CPR latch is fully
inserted into socket.
Secure air hose couplers
firmly into place.
Increase or decrease weight
setting until appropriate
pressure is reached.
Clean or replace air filter.
Make sure all air cells are
properly linked to air supply.
Check and adjust air tubes
positions.
Please contact Opera on
0333 222 8584 for assistance.