Table of Contents
Advertisement
A c a u t i o n : Read this page carefully to keep your safety.
Be sure to disconnect the power cable from the socket before conducting the following operation.
REPLACING THE FUSE
In case the fuse has blown, locate the cause. If the fuse
itself is the c a u s e , replace it a s follows:
1 . Pull the plug of the power cord from the power outlet.
2. Remove the fuse holder in the rear panel using a stan-
dard screwdriver (see Fig. 4 9 ) .
3 . T a k e out the blown f u s e , and in its place, insert a new
fuse.
4 . S e t the label of your line voltage to the mark • , then
plug the fuse holder containing the new fuse into the rear
panel.
Fuse holder
Fig. 4 9
34
MAINTENANCE
For Electric Shock Protection:
CHANGING THE SUPPLY V O L T A G E
Remove the fuse holder in the rear panel using a standard
screwdriver. T h e n set the label of your line voltage to the
mark •
changing the supply setting from 1 0 0 / 1 2 0 V to 2 2 0 / 2 4 0 V ,
change the 1 A fuse for a 0 . 5 A one. (see Fig. 4 9 )
and plug the fuse holder back into place. W h e n
Advertisement
Table of Contents
