Table of Contents
Advertisement
REPLACING T H E FUSE
In case the fuse has blown, locate the cause. If the fuse
itself is the cause, replace it as follows:
1. Pull the plug of the power cord from the power outlet.
2. Remove the fuse holder in the rear panel using a stan-
dard screwdriver (see Fig. 28).
3. Take out the blown fuse, and in its place, insert a new
fuse.
4 . Set the label of your line voltage t o the mark • , then
plug the fuse holder containing the new fuse into the
rear panel.
C H A N G I N G T H E SUPPLY V O L T A G E
Remove the fuse holder in the rear panel using a standard
screwdriver. Then set the label of your line voltage t o the
mark •
and plug the fuse holder back into place. When
changing
t h e
supply
setting
2 2 0 / 2 4 0 V, change the 0.8 A (0.5 A) fuse for a 0.5 A
(0.3 A) one. (see Fig. 28)
Value in parentheses (
) is for the CS-1025.
26
MAINTENANCE
f r o m
1 0 0 / 1 2 0 V
t o
Fig. 2 8
Advertisement
Table of Contents
