Maintenance - Kenwood CS-1065 Instruction Manual

REPLACING THE FUSE
In case the fuse has blown, locate the cause. If the fuse
itself is the cause, replace it as follows:
1. Pull the plug of the power cord from the power outlet.
2. Remove the fuse holder in the rear panel using a stan-
dard screwdriver (see Fig. 46).
3. Take out the blown fuse, and in its place, insert a new
fuse.
4. Set the label of your line voltage to the mark • , then
plug the fuse holder containing the new fuse into the
rear panel.
Fig. 4 6

MAINTENANCE

C H A N G I N G T H E S U P P L Y V O L T A G E
Remove the fuse holder in the rear panel using a standard
screwdriver. Then set the label of your line voltage to the
mark •
changing
2 2 0 / 2 4 0 V, change the 1 A fuse for a 0.7 A one. (see Fig.
46)
and plug the fuse holder back into place. When
the supply setting from 1 0 0 / 1 2 0 V to
3 3