Table of Contents
Advertisement
A Caution : Read this page carefully to keep your s a f e t y .
Be sure to disconnect the power cable from the socket before conducting the following operation.
REPLACING THE FUSE
In case the fuse has blown, locate the cause. If the fuse
itself is the cause, replace it as follows:
1. Pull the plug of the power cord from the power outlet.
2. Remove the fuse holder in the rear panel using a stan-
dard screwdriver (see Fig. 62).
3. Take out the blown fuse, and in its place, insert a new
fuse.
4. Set the label of your line voltage to the mark • , then
plug the fuse holder containing the new fuse into the
rear panel.
Fuse holder
Fig. 62
36
MAINTENANCE
For Electric Shock Protection:
CHANGING THE SUPPLY VOLTAGE
Remove the fuse holder in the rear panel using a standard
screwdriver. Then set the label of your line voltage to the
mark • and plug the fuse holder back into place. When
changing
220/240 V, change the 1.2 A fuse for a 0.8 A one. (see
Fig. 62)
the
supply
setting
from
100/120 V
to
Advertisement
Table of Contents
