Power Supply Wiring; Power Supply Connector Specifications; Wiring The Power Supply Connector - Omron CK3E Series Hardware User Manual

4 Mounting and Wiring
4-4

Power Supply Wiring

4-4-1

Power Supply Connector Specifications

The power supply connectors used for the Motion Controller are as follows.
One power supply connector is included in the Motion Controller.
Model
MVSTBW 2.5/3-ST-5,08 (1792760) Phoenix Contact
The following shows the pin assignment of the power supply connector used for the Motion Controller.
DIAG.
DC24V
INPUT +V -V
Pin Description
1 24 VDC
2 0VDC
3 Function grounding terminal
4-4-2

Wiring the Power Supply Connector

Compatible Wires
Wires that can be connected to terminal holes of the power supply connector are bar terminals attach-
ed to twisted wires, twisted wires, and solid wires.
Select a power supply conductor by considering voltage drops and heat due to the cable length within
your installation environment.
The following table provides information about the conductors that are compatible with this connector.
Solid wire
Twisted wire
Twisted wire with bar terminal, without plastic sleeve 0.25 to 2.5mm
Twisted wire with bar terminal, with plastic sleeve
Grounding
The type of grounding terminal onMotion Controlleris a functional ground terminal.
4-8
Manufacturer
1 2 3
Wire type
CK3E-series Programmable Multi-Axis Controller User's Manual Hardware (I610)
Conductor cross-sectional area
2
0.2 to 2.5mm
2
0.2 to 2.5mm
2
2
0.25 to 2.5mm
Conductor length
(stripping length)
7mm
7mm
7mm
7mm