IntelligentAg Recon Blockage Plus Operator's Manual page 16

5. Set alarm delays. Drag the Alarm Delay slider to adjust the number of seconds
between when the system detects a blockage and when the alarm sounds.
6. Change alarm volume. Drag the Volume slider to adjust the volume of alarms (unless
the volume is controlled by your device's side switch).
7. Enable and disable the section variance alarm. Toggle the Section Variance Alarm
switch to be notified of flow outside of your selected threshold for each section.
8. Set the section variance threshold. Drag the Variance Threshold slider to the
percentage difference at which you want to hear an alarm for individual sections.
600890-000075, rev 1.0
Recon Blockage Plus™ Operator's Guide
Page 16 of 26