Advertisement
• Failure to observe these basic instructions will reduce the performance and increase
noise levels of the cooker hood.
• Any installation work must be carried out by a qualified electrician or competent
person.
•Do not connect the ducting system of the hood to any existing ventilation system
which is being used for any other appliance ,such as warmer tube, gas tube , hot wind
tube.
•The angle of the bend of the expansion pipe should not be less than 120º; you must
direct the pipe horizontally, or, alternatively, the pipe should go up from the initial point
and should be led to an outer wall.
•After the installation ,make sure that the cooker hood is level to avoid grease
collection at on end.
•Ensure the expansion pipe selected for installation complies with relevant standards
and is fire retardant.
WARNING:
Start Using Your Cooker Hood
There are five buttons:
Pic above.
1. After connecting to power, indicator light will lit on, all the output close and the hood
will enter standby mode. The indicator light will be off automatically after reminding
if no operation.
2. Power on: Press power button
at low speed. Indicator light of low speed
• For safety reason, please use only the same size
of fixing or mounting screw which are
recommended in this instruction manual.
• Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards.
(Low),
(Mid),
once, its indicator light will lit on, the hood works
7
(High),
(Light),
will be bright. Press power button
(Power).See
Advertisement
