Download Print this page

Safety Instructions - Euro Appliances EBB900BK3R Usage And Care Manual

Advertisement

SAFETY INSTRUCTIONS

T
his manual explains the proper installation and use of your cooker hood, please
read it carefully before using even if you are familiar with the product.
The manual should be kept in a safe place for future reference.
Never to do:
• D
o not try to use the cooker hood
without the grease filters or if the
filters are excessively greasy!
• D
o not install above a cooker with
a high level grill.
• D
o not leave frying pans
unattended during use because
overheated fats or oils might catch
fire.
• N
ever leave naked flames under
the cooker hood.
• If the cooker hood is damaged,
do not attempt to use.
• Do not flambé under the cooker
hood.
• CAUTION: Accessible parts may
become hot when used with cooking
appliances.
• The minimum distance between the
supporting surface for the cooking
vessels on the hob and the lowest
part of the cooker hood. (When the
cooker hood is located above a gas
appliance, this distance shall be at
least 65 cm)
• The air must not be discharged into
a flue that is used for exhausting
fumes from appliances burning gas
or other fuels.
Always to do:
• Important! Always switch off the
electricity supply at the mains during
installation and maintenance such
as light bulb replacement.
• The cooker hood must be installed
in accordance with the installation
instructions and all measurements
followed.
• All installation work must be carried
out by a competent person or
qualified electrician.
• Please dispose of the packing
material carefully. Children are
vulnerable to it.
• Pay attention to the sharp edges
inside the cooker hood especially
during installation and cleaning.
• Make sure the ducting has no
bends sharper than 90 degrees as
this will reduce the efficiency of the
cooker hood.
• Warning: Failure to install the
screws or fixing device in
accordance with these instructions
may result in electrical hazards
• Warning: Before obtaining access to
terminals, all supply circuits must be
disconnected.
3

Advertisement

loading