2. The installation work must be undertaken by a qualified and competent installer in compliance with applicable Australian Standards. 3. Euro Appliances disclaims all liability for any damage or injury caused as a result of not following these instructions for installation.
Installation - Requirements Warning: This Canopy is not an outdoor appliance but it can be installed in an alfresco area in accordance with the following: Installation must be performed by a qualified competent installer. The canopy must not be exposed to rain, moisture or dust. ...
(3). Installation – Fitting the Canopy. The Alfresco Canopy must be placed at a distance of 65cm minimum from the cooking surface of a cooker/hotplate and 120cm minimum from the cooking surface of a BBQ. Fit the plastic flaps to the outlet vent of the canopy by deforming the flaps slightly so that the ends fit into the holes (refer to Pic 3 for location of the flaps).
Page 6
Note: Fix the Canopy with two 30mm safety screws. The two safety screw holes are positioned on the back casing (refer to Pic 5). Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. After installation, make sure that the canopy is level to avoid grease collecting at one end.
(4) Safety Warnings This Canopy is for domestic use only, it is not suitable for commercial purposes. Please ensure that installation is performed by a qualified competent installer. The Canopy and its filter mesh should be cleaned regularly in order to keep it in good working order.
(5) Instructions for Use Switch on the power to the Canopy. 1. Push the low button, the indicating light around the button will illuminate and the motor runs at low speed. Push it again and the motor will stop and the light will switch off. 2.
(6) Maintenance 6.1 Cleaning the filters The filters are made of stainless steel baffles. Please do not use corrosive or abrasive detergents to clean the filters. Keeping the filters clean will keep the appliance running correctly. Please strictly follow the guidelines below. Method 1: Put the baffle filter into a sink of clean water, pour on detergent, and soak for 2-3 minutes.
(7) Troubleshooting Warning: Service must be performed by an authorised competent person. Fault Cause Solution The flaps are blocked Remove the blockage. The capacitor is damaged Call for service. Light on, but motor The motor is jammed due to Call for service. does not work bearing damage There is a bad smell coming...
Page 11
Eurostyle Group trading as Euro Appliances Service Line: 1300 440 885 Fax: (08) 8165 1018 Email: services@eurostylegroup.com.au...
Need help?
Do you have a question about the EBB900SS and is the answer not in the manual?
Questions and answers