SAFETY INSTRUCTIONS This manual explains the proper installation and use of your cooker hood, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. Never to do: •...
Page 4
• Please dispose of the packing appliance by a person responsible material carefully. Children are for their safety. Children should be vulnerable to it. supervised to ensure that they do not • Pay attention to the sharp edges play with the appliance. Cleaning and inside the cooker hood especially user maintenance shall not be made during installation and cleaning.
• WARNING: Danger of Fire, do not • When the cooker hood and store items on the cooking surfaces. appliances supplied with energy other than electricity are • A steam cleaner is not to be used. simultaneously in • NEVER try to extinguish a fire with •...
Page 6
2. Decide the location of the holes for fixing the cooker hood. 3. Install the L-shaped bracket on the top of the hood with two screws (4 x 10mm). 4. The cooker hood is wall mounted with 4 screws (4 x 30mm) and wall plugs. Mount the cooker hood on the wall on the back of the cooker hood with 2 screws (4 x 30mm) and wall plugs.
Page 7
2. Drill 6 φ5mm holes in the plywood of the cabinet. 3. Mount the cooker hood on the cabinet with 6 screws (4 x 35mm) and flat washers. 4. Fix the expansion pipe on the outlet, and lead it to outdoors. If there is gap between the wall and the cooker hood, you may install the L-shaped bracket on the bottom of the hood with two screws (3 x 12mm).
WARNING: • For safety reason, please use only the same size of fixing or mounting screws which are recommended in this instruction manual. • Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
work, motor does Refit mains power cable to Mains power cable is loose or not work power outlet. Switch power disconnected outlet on. One way valve and the outlet Take down the one way valve are not tightly sealed and seal with sealant. Oil leakage Leakage from the connection of Take chimney down and seal.
Page 10
CONTROL PANEL SURFACE The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning. Important Using neutral detergents and avoid using harsh cleaning chemicals, strong household detergents or products containing abrasives, as this will affect the appearance of the appliance and potentially remove any printing of artwork on the control panel and will void manufactures warrantee.
Page 11
NOTE: • Make sure the filter is securely locked. Otherwise, it would loosen and cause danger. • When activated carbon filter attached, the suction power will be lowered. BULB REPLACEMENT Important : • The bulb must be replaced by the manufacturer, its service agent or similarly qualified persons.
ENVIRONMENTAL PROTECTION: This product is marked with the symbol on the selective sorting of waste electronic equipment. This means that this product must not be disposed of with household waste but must be supported by a system of selective collection in accordance with Directive 2012/19/EU.
Page 13
Pronto Service + Support: 1800 440 335 Email: service@eurostylegroup.com.au HEAD OFFICE 65 Glynburn Road, Glynde SA 5070 Ph: 08 8165 1012 www.euroappliances.com.au...
Need help?
Do you have a question about the ES602SS2 and is the answer not in the manual?
Questions and answers