Man D 2842 LE 620 Repair Manual page 115

Removing and fitting camshaft bearing bushes
Fig.31
Place the bearing bush with edge on the press-in
plate.
Caution:
D One oil hole of the bearing bush must
be fixed in place by the spring-loaded
ball
D The other oil hole must be flush with
the recess of the press-in plate
D The bearing bush must be seated up to
the stop on the press-in plate
Fig. 32
The oil holes are covered in that the press-in plate
is fixed in position by the groove of the shaft.
Drive in the bearing bush with striking weight Á.
Fig. 33
Check all the pressed-in bearing bushes for seat-
ing and free access to the oil holes.
Caution:
Check that the bearing hole matches up
to the oil hole in the housing.
Minimum cross section with mandrel
∅ = 2.5 mm.
31
32
33
113
2