Man D 2842 LE 620 Repair Manual page 110

Removing and fitting camshaft bearing bushes
Fitting the camshaft bearing bushes
Fig. 11
Depending on the number of the camshaft bearing,
there are various press-in plates (special too) for
pressing in the bearing bushes
À Shaft with groove and fixed stop
Á Striking weight for À
 Double-sided guide bush
à Press-out plate for bearing bushes 2 to 6
Ä Press-in plate for bearing bush 1
Å Press-in plate for bearing bushes 2 to 4
Æ Press-in plate for bearing bushes 5 and 6
Ç Press-in plate for bearing bush 7
Press in the camshaft bearing bush, bearing 2
Figs. 12 and 13
Place the bearing bush on the press-in plate Å.
Caution:
D One oil hole of the bearing bush must
be fixed in place by the spring-loaded
ball
D The other oil hole must be flush with
the recess of the press-in plate
D The bearing bush must be seated up to
the stop on the press-in plate
Fig. 14
Place the guide bush  on the shaft with groove,
ensuring that you have the correct bush side (the
sides have different diameters!).
When the shaft is put in place, the groove must
face upwards so that the guide bush is fixed in
place by the correct oil holes.
2
3 4
11
6
12
13
3
14
108
1
5 6 7 8