Table of Contents
Advertisement
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation
position of the drain hose.
Extend the drain hose from the side of spin tub
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Dismantle the drain hose fixing clamp and take
the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the side
of the spin tub in the order of (1)~(3), heading for the
side of the spin tub. (See to Figure 3).
Embed the drain hose into the groove with
hands. Take care not to damage the drain
hose in fastening the fixing clamp.
Extend the drain hose from the rear side
Dismantle the drain hose fixing clamp.
Take out the drain hose from the fixing groove.
Extend it from the rear side as per the direction
of the arrow. (When the drain hose is extended
from the rear side, it can be hung on the point
for drain hose at the two sides of the cabinet.)
(See to Figure 4).
Install the water inlet hose; Select the water level
Insert the water inlet hose into the water-filling
entrance on the control panel
To dismantle the water inlet pipe,
just push the control handle as indicated in the
figure and pull it out
Select water level according to the
quantity of the laundries.
Set the water level adjusting lever
to needed line.
Soft item
Drain hose fixing clamp
Soft item
Extend to the
spin tub side
Water inlet hose
Water level
indicator
Maximum
Water level
Max
adjusting lever
Med
Medium
Min
Minimum
Back
Front
Figure 1
Figure 2
Embed into the
groove in turn
Fig ure 3
Figure 4
Water-filling
entrance
5
Advertisement
Table of Contents
