Related Manuals for Haier HWM100-99VGS
Summary of Contents for Haier HWM100-99VGS
- Page 1 Twin-tub Washing Machine With Pump User's manual This manual is for Please read this manual carefully before using. Retain it for future reference.
-
Page 2: Table Of Contents
Contents Names of the parts Safety precautions Installation and adjustment Preparation before washing The musts in washing Usage of the detergent Washing sequence Disposal after washing Trouble-Shooting *Answers to question Packing list *Specification... -
Page 3: Names Of The Parts
Names of the parts Water-filling entrance Water inlet selector handle Buzzer Wash selector Wash timer Control panel Filter frame Lint filter Wash tub Pulsator Drain hose Wash tub cover Base frame Notes: All illustrations in this Manual are given for reference only. Your products and accessories may show differences from these illustrations due to our continuous improvement. -
Page 4: Safety Precautions
Safety precautions Please insert the power cord into special receptacle with rated vol- tage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector. Earth If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the customer care department. - Page 5 Safety precautions Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine.
-
Page 6: Installation And Adjustment
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the lint filter Put the underside of the lint filter into overflow filter then push the upside into overflow filter After installation,please refer that the lint filter installed to the right station,otherwise the lint... -
Page 7: How To Change The Direction Of The Drain Hoses
How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Extend the drain hose from the side of spin tub Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. - Page 8 In order to give you a quiet and comfortable washing,enclosed base frame and lower -noise motor have been designed to reduce the noise.With Haier machine, we believe that it is the right choice for your everyday.
-
Page 9: Preparation Before Washing
Preparation before washing Pay attention to followings before washing the laundries Check if Clear the the laundries pocket. Take has special out the coins, requirement sand, hairpins on washing etc. a. Check if the laundries are applicable for washing with machine. b. -
Page 10: The Musts In Washing
The musts in washing Usage of the detergent How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into thewashing tub. Avoid using whitener on laun- dries with color or pattern as they are prone to lose color. -
Page 11: Washing Sequence
Washing sequence Wash timer Wash selector (To set to below 2 minute, (standard current, first set to 5 minute then strong current) turn it back. it can increase the service life of the timer). STRONG SILK WOOL STANDARD DRAIN COTTON LINEN WASH SELECTOR WASH TIMER... - Page 12 Midway spinning 1.Put the laundries into the spin tub evenly and smoothly. 2.Spin (1) Put the gland in properly. Please put in the gland properly even if the laundries quantity is small. Push Gland Proper The laundries are slanting (2) Close the inner and outer cover of the spin tub. (3) Spin for 1-2 minutes.
-
Page 13: Rinse With Water-Filling
Rinsing Rinse with water-filling 1.Put the laundries into the wash tub. Select suitable current according to the laundries. 2.Adjust the water level Set the water level with water level adjusting lever according to the laundries quantity. Then fill suitable water continuously. 3.Rinse Adjust the wash timer to 5-7 minutes to do rinsing. -
Page 15: Disposal After Washing
Disposal after washing After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must be used during washing. -
Page 16: Cleaning The Overflow Filter
Cleaning the overflow filter 2. Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside overflow filter ( as indicated in Figure 1). 3. Cleaning the overflow filter Clean the lint around the filter and flush with tap water. 4. -
Page 17: Trouble-Shooting Answers To Question
Trouble-shooting Answers to question When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) After complete draining, set the "WASH SELECTOR" STRONG or STANDARD difficult for the frozen water to melt. When the water is frozen Pour hot water below 50 to soak it completely. - Page 18 Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company.
-
Page 19: Packing List
Packing list Name User's manual Water inlet hose Gland Twin-tub washing machine Specification Water level Water quantity about Rated washing capacity kg Rated spinning capacity kg Injection pressure Quantity One piece One piece One piece One set Maximum/99L Medium/77L Minimum/65L 10.0 0.02MPa~0.2MPa...