Progressive Dynamics PD1618 Installation And Operation Manual page 13

Display Operation
NOTE: To cycle through the display states simply press the select button. Display states cycle in order as listed on this page. The display
will skip un-available display states (see display state descriptions above for additional details).
DC Input Voltage

Battery indicator is illuminated

Volts indicator is illuminated

DC Input Voltage measurement is always available

DC Input Voltage measurement is the default display state on start up
AC Output Voltage

AC indicator is illuminated

Volts indicator is illuminated

AC Output Voltage measurement is available only when the inverter is
supplying power (not when the inverter is in shore power mode)
AC Output Power

AC indicator is illuminated

kW indicator is illuminated

AC Output Power measurement is available only when the inverter is sup-
plying power (not when the inverter is in shore power mode)
Error

Error code display is only available if the inverter is currently in an error
state

See Figure 13 for error code descriptions

See page 14 for troubleshooting guide if error code persists
Sleep

Only indicators that may be illuminated are: Power, Shore, Fault, and Low
Battery

Indicators in sleep mode will be noticeably dimmer than in any other state

The PD1600 series inverter display automatically enters sleep mode when
neither of the control buttons have been pressed for 30 seconds

The inverter will automatically exit sleep mode when any error occurs or
shore power is detected

To manually exit sleep mode press either button. Pressing the power button
will not turn off the inverter; it must be held for 5 seconds to power down.
Figure 15
Display States
13