Progressive Dynamics PD1618 Installation And Operation Manual page 12

Display Interface
Select Button Display Power Button
Figure 11
Display Features

Power Button: Press to turn on; hold to turn off

Select Button: Cycles between display states:
Input Voltage, Output Voltage, Output
Power, Sleep, Error Code (if applicable)

Power Indicator: Lights up green when the inverter is on

Fault Indicator: Flashes red when an error has occurred

Shore Indicator: Lights up yellow when AC input is detected

Low Bat Warning Indicator: Lights up red when the battery
is nearing the end of its charge

Sleep: Lights automatically dim after 30 seconds

Remote port for externally mounted display
Rear Remote Connection
Figure 12
NOTE: Remote display operates exactly the same as the dis-
play mounted to the inverter
PDI Comm Port RV-C Comm Port
Display Panel
PD1601 Remote Display
Error Condition
Code
Low battery volt-
E-1 age detected
High battery volt-
E-2 age shutdown
AC output over-
load shutdown
E-3
Over-temperature
shutdown
E-4
Internal Error
E-5
Short Circuit
E-6
DC Voltage Fail-
ure
E-7
Figure 13
NOTE: For troubleshooting error codes, consult page 14
Low Bat Warning Indicator Power Indicator
Figure 14
ERROR CODES
Description
Input voltage has dropped beneath 10.5V for
several seconds. The PD1600 series inverter
will automatically restart when the input
voltage reaches 12.0V.
Input voltage has surpassed 15.5V. The
PD1600 series inverter will automatically
restart when the input voltage falls below
15.0V.
Output power has surpassed the continuous
power limit or the peak power limit. The
PD1600 series inverter will not automati-
cally restart. A manual restart is necessary.
Internal temperature of the inverter has ex-
ceeded its safe operating limit. The PD1600
series inverter will automatically restart
when internal temperatures return to safe
operating conditions.
An internal error has been detected. The
PD1600 series inverter will not automati-
cally restart. A manual restart is necessary.
A short circuit has been detected on the AC
output of the inverter. The inverter will not
restart. A manual restart is necessary.
The DC input voltage has dropped unex-
pectedly while the inverter was running. The
inverter will not restart. A manual restart is
necessary.
Error Code Descriptions
Fault Indicator
Display Indicators
12
Shore Power Indicator