Table of Contents
Advertisement
Problem
The appliance stops during operation.
The cycle time is too long or unsatisfactory
drying result.
The display shows
The display shows Error code (e.g. E51).
1) After maximum 5 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets).
12.1 If the drying results are
not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The Heat Exchanger is clogged.
• There was too much laundry in the
appliance.
13. TECHNICAL DATA
Height x Width x Depth
Max. depth with the appliance door open
1)
Possible solution
Make sure that the laundry is not caught
between the appliance door and the rubber
seal.
Make sure that the water container is empty.
Press Start/Pause to start the programme
again.
Load is too small, increase the load or use
the Time Drying programme.
Make sure that the weight of the laundry is
suitable for the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Ensure that the room temperature is higher
than +5°C and lower than +35°C. Optimal
room temperature is 19°C to 24°C.
Set the Time Drying or the Extra Dry
programme. 2)
If you want to set a new programme,
.
deactivate and activate the appliance.
Make sure that the options are suitable for
the programme.
Deactivate and activate the appliance.
Start a new programme. If the problem
occurs again, contact the Service centre.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor (See chapter "Settings -
Adjustment of the remaining laundry
moisture degree " for better setting).
• The airflow slots are clogged.
• Room temperature is too low or too
high (optimal room temperature 19°C
to 24°C)
850 x 596 x 638 mm (maximum 662 mm)
1100 mm
ENGLISH
19
Advertisement
Chapters
Table of Contents
