Electrolux EDH903BEWN User Manual page 4

4 www.electrolux.com
your authorized vendor, can be used only with the
appliance specified in the instructions supplied with the
accessory. Read it carefully before installation (refer to
the Installation leaflet).
The appliance can be installed as freestanding or
•
below a kitchen counter with correct space (refer to the
Installation leaflet).
Do not install the appliance behind a lockable door, a
•
sliding door or a door with a hinge on the opposite side,
that would prevent the appliance door from being fully
open.
The ventilation opening in the base must not be
•
covered by a carpet, mat, or any floor covering.
WARNING: The appliance must not be supplied
•
through an external switching device, such as a timer,
or connected to a circuit that is regularly switched on
and off by a utility.
Connect the mains plug to the mains socket only at
•
the end of the installation process. Make sure that the
mains plug is accessible after installation.
If the mains power supply cable is damaged, it must be
•
replaced by the manufacturer, its Authorised Service
Centre or similarly qualified persons to avoid an
electrical hazard.
Do not exceed the maximum load of 9 kg (refer to the
•
"Programme chart" chapter).
Do not use the appliance if items have been soiled with
•
industrial chemicals.
Wipe away lint or packaging debris that has
•
accumulated around the appliance.
Do not run the appliance without a filter. Clean the lint
•
filter before or after each use.
Do not dry unwashed items in the tumble dryer.
•
Items that have been soiled with substances such
•
as cooking oil, acetone, alcohol, petrol, kerosene,
spot removers, turpentine, waxes and wax removers
should be washed in hot water with an extra amount of