English / USA
Closing the cap
:
Fit the cap – grip upright –marks
must line up.
:
Turn the cap clockwise as far as
stop (approx. a quarter turn).
:
Fold the grip flush with the top of the
cap.
:
If the grip does not lie completely
flush with the cap and the detent on
the grip does not engage the recess
in the filler neck, the cap is not
properly seated and tightened and
you must repeat the above steps.
20
Fitting the Harness
Shoulder strap
*
:
Put on the shoulder strap (1).
:
Adjust length until the springhook
(3) is at about the height of your
right hip with the unit attached.
*
see "Guide to Using this Manual"
Balancing the Brushcutter
1
3
2
:
Attach the spring hook (1) to the
clamp (2) on the drive tube.
:
Loosen the screw (3).
:
Slide the clamp up or down the drive
tube.
:
Tighten the screw moderately.
1
2
FS 100 RX