Mounting The Cutting Tools - Stihl FS 100 RX Instruction Manual

Mounting the Cutting Tools

Mowing tools
1
3
5
1 STIHL Supercut 20-2
2 STIHL Autocut 25-2
3 STIHL Autocut C 25-2
4 STIHL Trimcut 30-2
5 STIHL PolyCut 20-3
6 STIHL FixCut 25-2
!
Warning!
STIHL brushcutters with a loop handle
without barrier bar may be used only
with the above mentioned mowing
heads with nylon line or plastic blades.
FS 100 RX
Preparations
2
4
: Lay your brushcutter on its back
with the gearhead facing upward
6
English / USA
Blocking the Output Shaft
: Insert the stop pin* (2) or
screwdriver* (2) in the bore (3) in the
gearhead as far as stop, apply slight
pressure.
: Rotate nut or cutting tool on the
shaft (1) until the stop pin slips into
position and blocks the shaft.
After mounting the cutting tool,
remove the tool used to block the
shaft.
* Comes standard with the machine or
is available as special accessory –
see "Special Accessories"
15