Automatic Setup - Banner ABR 3000 Series Quick Start Manual

2. Find your reader in the list by matching its serial number (SN). The USB driver creates a virtual Ethernet connection with an IP address
that cannot be modified.
Tip: The USB unit is the one in the Sensor Neighborhood list without a
parameters).
3.
Double-click on or drag the

Automatic Setup

To begin configuration, the reader must be correctly mounted at the correct reading distance for your application so that its Field of View cov-
ers the application reading area.
1.
Click Open Device Configuration. The Open Device Configuration window opens showing the list of configurations (jobs) currently
saved on the device. For new devices, the only saved configuration is the Default configuration.
2. Click OK. The device enters Live Image Capture mode and begins acquiring images.
3. Place the application code
4. If needed, set the focus manually. See
5.
After the code is positioned, click
Note: If the image display area is too dark to see the images being captured, drag the Gain and Exposure Time
sliders to the right to increase visibility. This will not affect Automatic Setup.
6. Click Start Automatic Setup. The Automatic Setup window opens.
7. Select the correct reading conditions.
• Static Tuning—No maximum limit on exposure time
• Dynamic Tuning—Maximum allowable image exposure is automatically calculated using the parameters
• 1D code
9
Automatic Setup does not recognize the following symbologies: Postal Codes, Pharmacode, MSI, Standard 2 of 5, or Matrix 2 of 5, and Interleaved 2 of 5.
6
Figure 9. Sensor Neighborhood List
device icon into the Selected Device Information Area. Details about the device display in this area.
9
in front of the reader at the correct application reading distance.
Set the Focus on p. 2.
Pause to stop image acquisition.
Figure 10. Gain and Exposure Time
Figure 11. Automatic Setup
wrench icon (used for modifying the IP
P/N 207636 Rev. B
ABR 3000