Port Adapter Slot - Cisco PA-FE-FX Installation And Configuration Manual

Carefully slide the new port adapter into the port adapter slot until the connector on the
Step 4
port adapter is completely seated in the connector on the motherboard.
Replace the screw in the rear of the port adapter slot. (See Figure 3-5 for its location.) Do
Step 5
not overtighten this screw.
Reinstall the VIP2 in the system. To do so, follow the steps in the section "Installing a
Step 6
VIP2" in the configuration note Second-Generation Versatile Interface Processor (VIP2)
Installation and Configuration, which shipped with your VIP2.
If the interface cables are disconnected, reconnect the interface cables to the port
Step 7
adapters.
This completes the procedure for installing any type of port adapter on the VIP2. Proceed to
Chapter 7, "Installing PA-FE Port Adapter Interface Cables," to connect the necessary cables to your
port adapter.
Installing a Port Adapter
VIP2 and the PA-FE Port Adapters 3-7