Cisco PA-FE-FX Installation And Configuration Manual page 38

Removing a Port Adapter
Figure 5-1
Figure 5-2 shows a PA-FE-FX installed in slot 2 of a Cisco uBR7200 series router.
Figure 5-2
Removing a Port Adapter
Use the following procedure to remove a port adapter from a Cisco uBR7200 series universal
broadband router:
Step 1
Warning
not directly touch the backplane with your hand or any metal tool, or you could shock yourself.
Step 2
— For a Cisco uBR7246, slide the port adapter retention clip for the desired port adapter slot
5-2 PA-FE-TX and PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
Cisco uBR7200 Series with a PA-FE-TX in Slot 2—Cisco uBR7246
Cisco uBR7200 Series with an PA-FE-FX in Slot 2—Cisco uBR7246
Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do
Unlock the retaining mechanism of the port adapter:
down in the unlocked position. The retention clip remains in the unlocked position.
(See Figure 5-3.)
PA-FE-TX port
adapter
PA-FE-FX port adapter