Port Adapter Slot Locations On The Supported Platforms - Cisco PA-4C-E 1 Installation And Configuration Manual

ESCON Cable
The ESCON channel interface uses 62.5/125 micrometer, multimode, fiber-optic cable with male duplex
connectors at each end
specifications in and contact your cable supplier or the vendor of your host CPU to order the correct
ESCON cable.
Figure 5

Port Adapter Slot Locations on the Supported Platforms

The following sections provide port adapter slot locations and related information:
•
Cisco 7200 Series Routers and Cisco 7200 VXR Routers Slot Numbering
Cisco 7204 routers and Cisco 7204VXR routers have four slots for port adapters, and one slot for an
input/output (I/O) controller. The slots are numbered from the lower left to the upper right, beginning
with slot 1 and continuing through slot 4. You can place a port adapter in any of the slots (slot 1 through
slot 4). Slot 0 is always reserved for the I/O controller. The Cisco 7204 router and Cisco 7204VXR router
are not shown.
Cisco 7206 routers and Cisco 7206VXR routers have six slots for port adapters, and one slot for an
input/output (I/O) controller. The slots are numbered from the lower left to the upper right, beginning
with slot 1 and continuing through slot 6. You can place a port adapter in any of the six slots (slot 1
through slot 6). Slot 0 is always reserved for the I/O controller.
Cisco 7206 router. The Cisco 7206VXR router is not shown.
Note Interface ports are numbered from left to right starting with 0.
OL-3743-02
(Figure
ESCON Interface Duplex Connector for the ESCON Channel Port Adapter
Cisco 7200 Series Routers and Cisco 7200 VXR Routers Slot Numbering, page 9
PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration
5). ESCON cables are not available from Cisco. Refer to the ESCON
Figure 6 shows the slot numbering on a
Overview
9