Table of Contents
Advertisement
Figure 6-6
Placing the Port Adapter Retention Clip in the Locked
—
Position
Port adapters
•
For a Cisco uBR7223, place the port adapter lever in the locked position. (See
Figure 6-7.)
Figure 6-7
Placing the Port Adapter Lever in the Locked
—
Position
Port adapters
Note
If the port adapter lever does not move to the locked position, the port adapter is
not completely seated in the midplane. Carefully pull the port adapter halfway out of the
slot, reinsert it, and move the port adapter lever to the locked position.
This completes the procedure for installing a port adapter in a Cisco uBR7200 series router. Proceed
to Chapter 8, "Configuring the PA-E3 Interfaces," for information on how to configure your
port adapter interfaces.
Cisco uBR7246 Shown
Cisco uBR7223 Shown
Installing a Port Adapter
Port adapter
retention clip in
locked position
Port adapter
lever in locked
position
Cisco uBR7200 Series and the PA-E3 6-5
Advertisement
Table of Contents
