Table of Contents
Advertisement
•
For a Cisco uBR7223, place the port adapter lever in the unlocked position.
(See Figure 6-3.)
Figure 6-3
Placing the Port Adapter Lever in the Unlocked
Position
—
Port adapters
Grasp the handle on the port adapter and pull the port adapter from the router midplane,
Step 3
about halfway out of its slot. If you are removing a blank port adapter, pull the blank
port adapter completely out of the chassis slot.
Note
As you disengage the port adapter from the midplane, OIR administratively shuts
down all active interfaces on the port adapter.
With the port adapter halfway out of the slot, disconnect all cables from the port adapter.
Step 4
After disconnecting the cables, pull the port adapter from its chassis slot.
Step 5
Always handle the port adapter by the carrier edges and handle; never touch the
Caution
port adapter's components or connector pins. (See Figure 6-4.)
Figure 6-4
Handling a Port Adapter
Metal carrier
Printed circuit board
Cisco uBR7223 Shown
Removing a Port Adapter
Port adapter
lever in unlocked
position
Cisco uBR7200 Series and the PA-E3 6-3
Advertisement
Table of Contents
