Table of Contents
Advertisement
Caution
components or connector pins. (See Figure 5-3.)
Figure 5-3
Step 6
This completes the procedure for removing a port adapter from a Cisco 7200 series router.
Installing a Port Adapter
Following is the procedure for installing a new port adapter in a Cisco 7200 series router:
Step 1
Step 2
Step 3
Step 4
Figure 5-4
Slot
guide
Always handle the port adapter by the carrier edges and handle; never touch the port adapter's
Handling a Port Adapter
Metal carrier
Printed circuit board
Place the port adapter on an antistatic surface with its components facing upward, or in a
static shielding bag. If the port adapter will be returned to the factory, immediately place
it in a static shielding bag.
Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
Remove the new port adapter from its antistatic container and position it at the opening
of the slot. (See Figure 5-4.)
Use both hands to grasp the port adapter by its metal carrier edges and position the port
adapter so that its components face downward. (See Figure 5-3.)
Align the left and the right edge of the port adapter metal carrier between the guides in
the port adapter slot. (See Figure 5-4.)
Aligning the Port Adapter Metal Carrier Between the Slot
—
Guides
Cisco 7206 Shown
Installing a Port Adapter
ETHERNET 10BT
FAST ETHERNET INPUT/OUTPUT CONTROLLER
Note: This adapter alignment
applies to any port or service
adapter.
Cisco 7200 Series and the PA-E3 5-3
TOKEN RING
Advertisement
Table of Contents
