Table of Contents
Advertisement
Installing a Port Adapter
Figure 4-3
Step 8
This completes the procedure for removing a new port adapter on a Catalyst RSM/VIP2.
Installing a Port Adapter
The following is the standard procedure for replacing a port adapter on the Catalyst RSM/VIP2:
Step 1
Step 2
Step 3
4-4
PA-E3 Serial Port Adapter Installation and Configuration
Pulling a Port Adapter Out of a Slot
If you removed a port adapter, place it in an antistatic container for safe storage or
shipment back to the factory. If you removed a blank port adapter, no special handling is
required; however, store the blank port adapter for potential future use.
Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
Remove the new port adapter from its antistatic container and position it at the opening
of the slot.
Carefully align the port adapter carrier between the upper and the lower edges of the port
adapter slot, as shown in Figure 4-4.
—
Partial Port Adapter View
Advertisement
Table of Contents
