Table of Contents
Advertisement
Installing a Port Adapter
Figure 4-5
Port Adapter Installed in a Port Adapter Slot
Step 5
Step 6
Step 7
This completes the procedure for installing a port adapter on a Catalyst RSM/VIP2. Proceed to
Chapter 8, "Configuring the PA-E3 Interfaces," for information on how to configure your port
adapter interfaces.
4-6
PA-E3 Serial Port Adapter Installation and Configuration
Replace the screw in the rear of the port adapter slot. (See Figure 4-2 for its location.) Do
not overtighten this screw.
To reinstall the Catalyst RSM/VIP2 in the system, follow the steps in the Route Switch
Module Catalyst VIP2-15 and VIP2-40 Installation and Configuration Note (Document
Number 78-4780-01), which shipped with your Catalyst RSM/VIP2.
If the interface cables have been disconnected, reconnect the interface cables to the port
adapters.
—
Partial Port Adapter View
Advertisement
Table of Contents
