Switching Off - Stihl KGA 770 Instruction Manual

English
10.2 Guide Roller
The guide roller makes it easier to control the
sweeper along edges, e.g. next to walls or curbs.
10.3 Hold-Down Device
The hold-down device can be pushed down to
keep the bristles close to the ground when
sweeping along edges, e.g. next to walls or
curbs.
► Push down knob on hold-down device.
10.4 Thermal Overload Cutout
The thermal overload cutout interrupts the power
supply if the motors are overloaded, e.g. if a side
broom or roller brush is blocked.
If the overload cutout has interrupted the power
supply:
► Switch off the machine – position 0 – and
remove the battery.
► Remove blockage from side brooms or roller
brush.
► Wait about 30 seconds for overload cutout to
cool down.
32
The thermal overload cutout for the side brooms
resets automatically, while the overload cutout
for the roller brush has to be reset manually by
pressing the switch (1).
► Fit the battery and switch the machine on
again – set on/off switch to I.

11 Switching Off

► Switch off the machine – position 0
Always remove the battery from the power tool
during work breaks and after finishing work.
11.1 Removing the Battery
1
► Press in both locking tabs (1) at the same time
to unlock the battery (2).
► Take the battery (2) out of the housing.
When the power tool is not in use, shut it off so
that it does not endanger others.
Secure it against unauthorized use.
11 Switching Off
1
2 1
0458-769-9821-B