Installation - Haier XQG65-11SU User Manual

Installation

Connection of water inlet hose and washing machine
1. Place the water inlet hose nut on the
connector of the water inlet valve.
2. Make sure that the water inlet hose is
fixed tightly and properly.
Water drain hose
The height of the water drain hose terminal should be
between 80cm and100cm. The water drain hose must be
securely placed on the clip at the rear of the washing
machine.
Use the water drain support supplied as an
accessory to install the water drain hose. Fix the water
drain hose support with a waterproof ring. Do not use an
excessively long water drain hose and contact an
authorised technician if the water drain hose needs to be
extended. The water drain hose should not be extended
more than 250 cm (a longer extension will result in
concurrent water inflow and outflow). The diameter of the
extension hose should be the same as the original hose.
Caution: the water drain hose must not be immersed in
water. The original hose and the extension must be
connected tightly.
Connection of power supply
Check the following items before connecting the appliance to the power supply.
The socket conforms to the maximum power load (the maximum current
load of the socket and power supply cable should not be less than 15A).
The power supply voltage conforms to the required value.
The power supply socket and plug of the washing machine are compatible;
if they are not compatible, contact a washing machine technician or a Haier
designated service point for power cable replacement. The washing machine
must be connected to the earth before use.
A supplementary earth cable should not be necessary if the socket is
connected to the earth.
A supplementary earth cable should be installed on the upper rear part of
the washing machine and connected to the earth if the power supply socket has
no earth connection.
Caution: the supplementary earth cable should not be connected to water or
heating pipes.
water inlet valve connector
water inlet hose nut
5