Assemble Dc Connectors - Delta BX6.3 DD Operation And Installation Manual

3.5 Assemble DC connectors

Prepare for expansion battery pack.
BX series uses Amphenol H4 connectors which provide along with the package
of BX6.3_EX100 are genuine parts that are certified the quality and reliable from
DELTA. Please follow the below requirements to choose the DC cable and crimp.
- DC cable must choose the cooper conductor which insulation is above 600V
withstands voltage.
- Acceptable cross-section range of the conductor is 4.0mm²~6.0mm².
- Recommend crimping is by using Amphenol special tool (H4TC0002)
- If accessories DC connectors are in shortage or have other application issues,
please contact DELTA Service Center for help.
Assemble Battery connectors:
Please follow step to assemble DC connectors.
(1) Male connector with Socket Type terminal is for Positive side.
Female connector with Pin Type terminal is for Negative side.
(2) Strip off the cable insulation around 6.5 ~ 7.5 mm length, neat the conductor,
then put it into its belong terminal hole well.
(3) Put them into the stopper of the Amphenol crimping tool(H4TC0002), then
crimp to fix.
(4) Connect the terminal and its belonging connector. The terminal will be
locked if well assembling. Fasten the cap with 2.6 ~ 2.9 N.m force for
the waterproof.
6.5 ~ 7.5 mm
27
Installation