Sony SX-M700 Service Manual page 33

SX-T100
Cables
PC support
Anchor
Cabinet
2 Removal of the Acoustic Coupler
1. Remove the AU-202 Board.
2. Remove the two fixing screws "a" (PTP 3x8),
then remove the acoustic coupler.
SX-M700
1 Removal of the AU-202 Board
1. Disconnect the connector (CN1) from the AU-202 board.
2. Unsolder the six cables connected to the TP terminals on
the AU-202 board using a soldering iron.
3. Release the two mechanical locks of the PC supports securing
TP
the AU-202 board, then remove the AU-202 board.
terminals
TP
Terminals
Cables
Screw "a"
(2 pcs)
PTP 3x8
4 Removal of the SW-704 Board
1. Disconnect the connector (CN1) from the AU-202 board.
2. Remove the nut and 6 mm poly-washer securing
the switch.
3. Remove the SW-704 board together with the supplied
washer and inner toothed washer.
Swtich
CN1
PC Support
Anchor
Poly-washer
CN2
Screw "b" (2 pcs)
PTP 2.6x6
3 Removal of the RP-type 6-pin Connector
1. Disconnect the connector (CN2) from the SW-704 board.
2. Unscrew the four screws "b" (PTP 2.6x6), then disconnect
the RP-type 6-pin connector.
Lug terminal
Inner toothed washer,
6 mm diameter
Supplied washer
Supplied nut
Screw "b" (2 pcs)
PTP 2.6x6
2-3(E)