Sony SX-M700 Service Manual page 32

Connector
CN903
Screw "c"
PSW 4x8
GND Lug
Screw "b" (2 pcs)
BVTP 3x8
TYPE 2
Connector
(from PS-364
Harness
board)
S O
N Y
Power lamp
Harness clamp
2 Removal of the Rear Panel Assembly
1. Release the power lamp harness from its
harness clamp. Disconnect the connector from
the power lamp.
2. Remove the two fixing screws "b" (BVTP 3x8)
from the left and right side panels, then remove
the front panel assembly in the direction of arrow B.
Screw "a" (5 pcs)
B 3x6
TYPE 2
PS-363 board
Screw "d"
PSW 4x8
PS-364 board
B
Front panel assembly
1 Removal of the Top Panel
1. Remove the ten fixing screws "a" (B 3x6).
2. Remove the top panel the direction of arrow A.
Screw "a" (5 pcs)
B 3x6
TYPE2
A
Screw "f" (2 pcs)
BVTP 3x8
TYPE 2
GND Lug
C
Connector
CN908
(from AC Inlet)
AL-31 board
Harness tie band
Screw "b" (2 pcs)
BVTP 3x8
TYPE 2
Screw "e" (3 pcs)
B 2.6x6
Screw "f" (2 pcs)
BVTP 3x8
TYPE 2
3 Removal of the Front Panel Assembly
1. Remove the top panel.
2. Release the power lamp harness from its harness clamp.
Disconnect the connector from the power lamp.
3. Cut the harness tie band.
4. Remove the fixing screw "c" (PSW 4x8) securing the GND
lug of the harness coming from the connector (CN903).
5. Disconnect the connector (CN903) from the PS-364 board.
6. Disconnect the connector (CN908) from the AL-31 board.
7. Remove the fixing screw "d" (PSW 4x8) securing the GND
lug of the PS-363 board.
8. Remove the three screws "e" (B 2.6x6) near the connectors.
9. Remove the four fixing screws "f" (BVTP 3x8), then remove
the rear panel assembly in the direction of arrow C.