Table of Contents
Advertisement
AS-i flat cable splitter
Step 2:
Insert cables
Step 3:
Fit upper part
u Recheck all torques 10 days after the initial installation and retighten, if necessary.
2
3
4
5
u Insert the yellow AS-i flat cable (2) into the cable
duct "AS-i".
u Insert the black 24 V flat cable (3) into the other
cable duct.
If no additional power supply is required:
u Insert the supplied cable dummy instead of
the 24 V flat cable to close the unused
cable duct.
u Place the upper part.
u Tighten the fixing screws (4) with 2.5 Nm.
u Remove protective cap from the M12 socket (5)
and manually fix the M12 connector using the
coupling nut. Tighten until you feel the end stop.
u Check the torque (1.3 Nm +/- 0.1 Nm) at the end
stop with a torque wrench and retighten, if
necessary.
E70354 E70372
7
Advertisement
Table of Contents
