Perenio PECLS01 Quick Start Manual

Dear Customer, thank you for choosing Perenio® products!
The Leak Sensor is generally intended to timely alert Users of water floods
and spills of other liquids in the area of installation. It is used as part of
the Perenio Smart Building Management System upon detection by
the Control Gateway (CG).
BASIC FUNCTIONS AND KEY BENEFITS
For indoor installation (Outdoor installation is possible)
Battery operated (DC 3V, 1300 mAh), high-decibel alarm (up to 65dB),
iOS & Android smartphone compatibility, IP67 Protection class, support
of ZigBee 3.0, accurate triggering, 1.5 mm liquid level actuation, floating
function, low power consumption, compact and stylish design.
PACKAGE CONTENTS:
PECLS01 Leak Sensor (1 pc.), CR123A Battery (1 pc.), Quick Start Guide
(1 pc.), Warranty Card (1 pc.).
INSTALLATION AND CONFIGURATION
1. Make sure that the Perenio® Control Gateway was pre-installed and
connected to the network through Wi-Fi/Ethernet.
NOTE. The Control Gateway may be purchased as a standalone device or as part of
the Perenio® Smart Kit.
2. Unpack the Leak Sensor, open the device cover and remove the battery
insulating film to power on the sensor. Close the device cover.
Doc Date: November 1, 2018
©Perenio IoT spol s r.o.
Version: 1.4.0
All Rights Reserved
1