Removing The Dfc3 Daughter Card - Cisco DFC3B Installation Note

Distributed forwarding card 3 for ws-x67xx modules

Hide thumbs Also See for DFC3B:

Figure 2

Step 6

Gently lift the CFC daughter card with both hands and remove the CFC daughter card from the module.

Step 7

Place the CFC daughter card on an antistatic mat, antistatic foam pad, or in an antistatic bag.

Proceed to the

Step 8

Removing the DFC3 Daughter Card

This section contains two DFC3 daughter card removal procedures. The first procedure describes how

to remove the DFC3 daughter card from modules that are not equipped with a stiffener bracket. The

second procedure describes how to remove the DFC daughter card from early versions of the

WS-X6748-GE-TX Ethernet module that are equipped with a stiffener bracket.

Only some versions of the WS-X6748-GE-TX Ethernet module are equipped with a stiffener bracket.

Note

78-15893-08

Unseating the CFC Daughter Card Connectors

WS-X5530

"Installing the DFC3B and DFC3C Daughter Cards" section on page

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

Removing a CFC or DFC Daughter Card

Heat sinks

23.

Table of Contents

Dfc3a Dfc3bxl Catalyst 6500 series