Advertisement
To remove a DFC3 daughter card from a WS-X6748-GE-TX Ethernet module that is equipped with a
stiffener bracket, follow these steps:
Attach an ESD grounding strap to your wrist and to ground.
Step 1
If you are unsure about the correct way to attach an ESD grounding strap, refer to the
ESD Grounding Strap" section on page 42
Remove the WS-X6748-GE-TX Ethernet module from the Catalyst 6500 series switch.
Step 2
If you are unsure about the correct procedure for removing a module from the switch chassis, refer to
the
"Removing and Installing Ethernet Modules in the Chassis" section on page 34
instructions.
Place the module on an antistatic mat or antistatic foam with the front of the module facing toward you.
Step 3
If your DFC daughter card has a small metal installation bracket as shown in
Step 4
Phillips-head screwdriver to remove the two cap nuts and the one screw securing the bracket. Set them
aside with the bracket. If there is no installation bracket, remove the two cap nuts and the one screw.
Step 5
Use a Phillips-head screwdriver to remove the remaining installation hardware. (See
Figure 7
Stiffener
bracket
78-15893-08
for instructions.
Removing the Installation Hardware (DFC3B/DFC3BXL Shown) (WS-X6748-GE-TX
Equipped with a Front Stiffener Bracket)
WS-X5530
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
Removing a CFC or DFC Daughter Card
Figure
Stiffener bracket tabs, DFC
daughter card mounted
underneath tabs.
"Attaching Your
for removal
7, use a No.1
Figure
7.)
Installation
bracket. May
or may not
be present
17
Advertisement
