Attaching Your ESD Grounding Strap
Figure 31
ESD ground
strap
When handling modules, follow these additional guidelines:
Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
•
connectors.
Place a removed component board-side-up on an antistatic surface or in a static-shielding container.
•
If you plan to return the component to the factory, immediately place it in a static-shielding
container.
Never attempt to remove the printed circuit board from the metal carrier.
•
Caution
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
between 1 and 10 megohm (Mohm).
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
44
Attaching the ESD Wrist Strap Clip to the System Ground Lug Screw
Clip
Screw
Slide clip
behind screw
Clip installed
behind screw
WS-X6 K-SUP 2-2GE
CONSOL E
PORT
MODE
CONSOL E
SUPER VISOR 2
PCMCIA
EJECT
OSM-4OC 12 POS-SI
4 PORT OC-12 POS
SM IR
OSM-4OC 12 POS-SI
4 PORT OC-12 POS
SM IR
Grounding lug
Side view of
grounding lug
System ground
connector
Switch
Load
100%
PORT 1
PORT 2
1%
78-15893-08